PHILEO LT pH Regulation - CCEI
  • PHILEO LT pH Regulation - CCEI
  • PHILEO LT pH Regulation - CCEI
  • PHILEO LT pH Regulation - CCEI

PHENIX pH and ORP automatic regulator - CCEI

avis sur ce produit
€579.17
Quantity

PF10J025

The Phenix regulator combines the pH regulation and RedOx analysis

It is designed to support the salt chlorinator, it guarantees the high efficiency for pool water treatment. 

PH regulation: water balance regulation

It regularly controls the pH balance of the pool water and the digital monitor displays the metered quantity. To increase the efficiency of the injected chlorine into pool water, the pH balance must be measured between 7,0 and 7,6. The PHENIX regulator controls and regulates the pool water acidity for optimized water treatment. 

Automatic pH regulation 

The Phenix automatically adapts its correcting solution injection depending on measured pH. The pH probe placed after filtration allows to control pH balance and to adapt the regulation.  

RedOx  regulation: to measure the oxidizing potential of the pool.

The Phenix is a analysis device  for measuring redox potential of the pool water. This redox potential or ORP (Oxydo Reduction Potential) is expressed in millivolts (mV) and shows an indication of water disinfectant capacity and sanitary state. The higher the potential, the highest water disinfectant power. Generally, the potential has to be placed between 550mV and 800mV. For public pools, legislation requires the minimum potential between 650mV and 750mV depending on countries.

When the measured RedOx potential is under the nominal value, the Phenix regulator activates the closure of the relay which can be used to control dosing pump or chlorine production of the chlorinator.

Installation of Phenix regulator

Schéma de montage du Phenix

Accessories supplied with The Phenix

  • 4 m of crystal tube
  • 3 sockets of 50 mm
  • 1 Suction strainer for pH corrector
  • 1 Injector
  • 1 pH7 Calibration solution
  • 1 pH9 Calibration solution
  • 1 650mV calibration solution
  • 1 pH probe
  • 1 RedOx (ORP) probe
  • 2 probe supporting
  • 1 enslaving cord

Data sheet

Etanchéité:
IP-55
Plage de mesure:
pH meter between 3,9 and 9,9 RedOx analysis between 10 and 990mV
Précision de la mesure:
+/- 0,1
Affichage digital:
OUI
Alimentation:
230V - 50Hz - single phase power supply
Débit maximum:
1,8 l/h
Construction:
CCEI
Guarantee:
2 years
Accessoires:
4 m de tube cristal. 3 Prises en charge en 50 mm 1 Crépine d’aspiration pour correcteur pH 1 Injecteur 1 Solution d’étalonnage à pH7 1 Solution d’étalonnage à pH9 1 Solution d’étalonnage à 650mV
Description:
pH regulation and ORP analyzer for salt electrolysis

Specific References

Download

testok

Notice d'utilisation Phenix

Download (880.43k)
testok

operating instructions phenix

Download (840.21k)

SELECTIONNER UN MODELE

Selectionner une variante ci dessous

  • PHILEO LT pH Regulation - CCEI
  • PHILEO LT pH Regulation - CCEI
  • PHILEO LT pH Regulation - CCEI

CARACTERISTIQUE TECHNIQUES

Cliquez sur un equipement pour en savoir plus

Data sheet

  • Etanchéité:

    IP-55
  • Plage de mesure:

    pH meter between 3,9 and 9,9 RedOx analysis between 10 and 990mV
  • Précision de la mesure:

    +/- 0,1
  • Affichage digital:

    OUI
  • Alimentation:

    230V - 50Hz - single phase power supply
  • Débit maximum:

    1,8 l/h
  • Construction:

    CCEI
  • Guarantee:

    2 years
  • Accessoires:

    4 m de tube cristal. 3 Prises en charge en 50 mm 1 Crépine d’aspiration pour correcteur pH 1 Injecteur 1 Solution d’étalonnage à pH7 1 Solution d’étalonnage à pH9 1 Solution d’étalonnage à 650mV
  • Description:

    pH regulation and ORP analyzer for salt electrolysis

You might also like

Cliquez sur un equipement pour en savoir plus